Out of border error, wont back out of base.

[AekaGSR]

Suddenly my LB35xx will not back out of the base, it will try and rotate inside the base and sync, it won't find a signal here.
When I place it in the yard and start it, it will throw an "out of border" message during sync.

I have 6 ohms of resistance on the wire, and the signal indicator is flashing correctly.   What could have happened?

[AekaGSR]

So I decided to place the mower outside of the boundary and it grabbed signal.  It thinks its outside when it is inside and inside when it is outside.  I haven't touched the wires to the base, so why has it decided to reverse its deal?

[AekaGSR]

It wanting to work outside the border must have been a fluke.  So it basically just won't go no matter where I put it.  A couple of times it did make a quarter turn before throwing the out of border error.


edit: I put a test wire out and it still failed.

[RobotLady]

What error message is shown on the display?

[AekaGSR]

I just wanted to thank RobotLady for her dedication on jump starting the lawnbott/Ambrogio  line.  I had two things broken, my transmitter and a wheel motor.  Everything now works as it should thanks to the Paradise Robotics team.

[RobotLady]

You're welcome!